For replacement of any adhesive-installed window, use the full cut method only.
Use an adhesive that is approved by GM, Specification GMW-15672.
Use these materials based on specific manufacturer. Do NOT intermix primers or adhesives from one manufacturer to another.
Always follow the system manufacturers instructions for application, handling, and curing.
Sunroof Window Seal Replacement
Side WindowsBackup Lamp Switch Replacement
Removal Procedure
Disconnect the electrical connector from the backup lamp switch?€‰(1).
Remove the backup lamp switch?€‰(1) from the transmission.
Remove and DISCARD the backup lamp switch washer from the backup lamp
switch.
Installation Proc ...
Fuel Injection Fuel Rail Assembly Replacement
Removal Procedure
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection
and Connection.
Remove engine cover. Refer to Engine Cover Replacement.
Remove the fuel feed pipe from fuel injection fuel rail. Refer to Fuel
Feed Pipe Replacement.
Re ...
Starter Replacement (LUV)
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and Connection.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
If equipped with a front suspension skid plate, remove the drivetrain
...