Chevrolet Sonic Repair Manual: Body Panel Paint Protector Replacement (VGC)
- The paint protective film and vehicle surface temperature should be 13?€“32?°C (55?€“90?°F) for best results.
- Automatic car washes should be avoided for at least 24?€‰hours after the paint protective film application.
- Wipe the vehicle surface with isopropyl alcohol or flash naptha at the application area.
- Dry the surface with a clean lint-free cloth.
- Create a mixture of 25 percent isopropyl alcohol and 75 percent water and two drops of baby shampoo per 16?€‰oz of fluid mixture.
- Remove the backing liner from the protective film patch.
- Use the solution to liberally spray the adhesive side of the protective patch, the mounting location along with your hands.
- Position the paint protective film patch to the desired location on the vehicle.
- Spray the surface of the film with the alcohol, water and soap solution.
- Using a dampened squeegee, start at the center of the protective patch, working outward in order to remove the air and solution from under the protective patch.
- Release any air bubbles with a pin.
- Dry the surface with a clean, lint-free cotton cloth.
Panels
...
Front End Upper Tie Bar Replacement
Front End Upper Tie Bar Replacement
Callout
Component Name
Preliminary Procedures
Disable the SIR system. Refer to SIR Disabling an ...
Other materials:
Rear Side Door Upper Rear Trim Panel Replacement (Hatchback)
Rear Side Door Upper Rear Trim Panel Replacement
Callout
Component Name
1
Rear Side Door Upper Rear Trim Panel Assembly
Procedure
Pull the door upper rear trim panel away from the rear side door.
...
Brake Rotor/Drum Balance Inspection
Support the vehicle drive axle on a suitable hoist. Refer to Lifting and
Jacking the Vehicle.
Remove the tire and wheel assemblies from the drive axle. Refer to Tire
and Wheel Removal and Installation.
Warning: Refer to Work Stall Test Warning.
Reinstall the wheel nuts in ...
Heater Inlet Hose Replacement (LDE, LUW)
Special Tools
BO-38185 Hose Clamp Pliers
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Drain the cooling system. Refer to Cooling System Draining and Filling.
Disengage the heater inlet hose quick connect clip (1) at the heater
...
0.007