Immobilizer System Component Programming
This procedure will learn the immobilizer function. If the battery voltage is
low, charge the battery before proceeding with the learn. If the body control module
(BCM) or engine control module (ECM) have been replaced, they must be programmed
before performing this learn procedure.
Dependin ...
Engine Block Disassemble
Remove the cylinder head locating (1, 2).
Remove the oil pressure switch (1).
Remove the knock sensor bolt (2) and the knock sensor (1).
Clean the thread.
Remove the oil flow check valve (1).
Remove the oil pressure rel ...
Manual Shift Shaft Seal Removal
Manual Shift Shaft Seal Removal
Callout
Component Name
1
Manual Shift Shaft Seal
Note: Use the DT-45201 seal remover to remove the seal
to prevent damage to the case surface.
Special Tools
DT-452 ...