Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Driver or Passenger Seat Back Cushion Frame Replacement

Chevrolet Sonic Repair Manual / Body / Seating / Seats / Information / Driver or Passenger Seat Back Cushion Frame Replacement



Driver or Passenger Seat Back Cushion Frame Replacement

Callout

Component Name

Preliminary Procedures

  1. Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation
  2. Remove the front seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement
  3. Remove the front seat cushion inner recliner. Refer to Front Seat Cushion Inner Trim Panel Replacement

1

Front Seat Back Cushion Frame Bolt (Qty:?€‰4)

Caution:

Refer to Fastener Caution.

Tighten


22?€‰Y(16?€‰lb?€‰ft)

2

Driver or Passenger Seat Back Cushion Frame

Procedure

  1. Disconnect electrical connectors as needed.
  2. If replacing with a new front seat back cushion frame, transfer components as necessary.
Driver or Passenger Seat Back Cover and Pad Replacement
Driver or Passenger Seat Back Cover and Pad Replacement Callout Component Name Warning: Refer to SIR Warning. War ...

Driver or Passenger Seat Back Cushion Heater Replacement
Driver or Passenger Seat Back Cushion Heater Replacement Callout Component Name Warning: Refer to SIR Warning. Prelimi ...

Other materials:

Automatic Transmission
P (Park): This position locks the front wheels. It is the best position to use when you start the engine because the vehicle cannot move easily. Warning It is dangerous to get out of the vehicle if the shift lever is not fully in P (Park) with the parking brake firmly set. The vehicle can ro ...

Checking Coolant
The vehicle must be on a level surface when checking the coolant level. It is normal to see coolant moving in the upper coolant hose return line when the engine is running. Check to see if coolant is visible in the coolant surge tank. If the coolant inside the coolant surge tank is boiling, do ...

Hood Ajar Indicator Description and Operation
Hood Ajar Switch The body control module (BCM) applies B+ to the hood ajar signal circuit and monitors the voltage to determine the position of the hood. When the hood is closed, the switch is open and voltage remains high. When the hood is open, the switch is closed and the voltag ...

© 2014-2026 Copyright www.csmans.com
 
0.0077