Chevrolet Sonic manuals

Audi Q7 (4M) 2016-2022 Owner's Manual: Electromechanical parking brake

Operating the parking brake

The electromechanical parking brake is used to secure the vehicle from rolling away unintentionally.

The switch is located under the selector lever in the center console. It turns on when the parking brake is set. You can release the parking brake manually or automatically when you start to drive.

Setting and releasing the parking brake

If the red indicator light flashes, the braking force has not built up enough or it has decreased.

You can also secure the vehicle by selecting the "P" gear or pressing the brake pedal. Make sure the indicator light is off before you start driving.

Automatically releasing the parking brake when starting to drive

Requirement: the driver's door must be closed and the driver's safety belt must be fastened.

WARNING

Tips

Emergency braking function

Emergency braking should only be used in an emergency, if the standard brake pedal is malfunctioning or obstructed. When the emergency braking function is activated, the braking effect is similar to a heavy braking maneuver.

WARNING

Heavy braking while driving through curves or in poor road or weather conditions can cause the vehicle to slide or the rear of the vehicle to swerve, which increases the risk of an accident.

Messages

The following messages may appear depending on the vehicle equipment:

Parking brake: malfunction! Safely stop vehicle. See owner's manual

Parking brake: malfunction! Please release parking brake

If one of the two messages appears, there is a malfunction in the parking brake. If the message appears while stationary, check if the parking brake is released and can be reset. If this is the case, switch the ignition off and back on.

If the message stays on, if the parking brake cannot be released, or if the message appears while driving, do not continue driving. Secure the vehicle against rolling before exiting the vehicle. See an authorized Audi dealer or authorized Audi Service Facility for assistance.

Parking brake: malfunction! Please contact Service

There is a malfunction in the parking brake. Drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected. Do not park the vehicle on inclines and shift to "P".

Parking brake: warning! Vehicle position too steep

The braking force may not be enough to secure the vehicle from rolling away. Park the vehicle in a place with less of an incline.

Parking brake: applied

The parking brake is set. Press and hold the brake pedal to release the parking brake.

Brakes
General information You can apply the vehicle's brakes using the brake pedal. Operating noise Noises may occur when braking depending on the speed, braking force, and outside conditions such as temper ...

Special driving situations
Driving uphill and downhill When driving uphill, downhill, or at high altitudes, note the following information: Drive slowly and carefully. Do not try to turn around if you cannot safely drive on ...

Other materials:

Infotainment
Determine which radio the vehicle has and read the following pages to become familiar with its features. Warning Taking your eyes off the road for extended periods could cause a crash resulting in injury or death to you or others. Do not give extended attention to infotainment tasks while dr ...

Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto the balancer. The pilot bore (on the hub side of the wheel) is machined to be concentric to very tight non - standard tolerances. The bottom cap bore is not machined to this same degree of precision. Accurate mac ...

Input and Output Speed Sensor Removal
Input and Output Speed Sensor Removal Callout Component Name 1 A/Trans Output Speed Sensor Bolt M6 x 18 (Qty: 1) 2 A/Trans Output Speed Sensor Assembly ...

В© 2014-2022 Copyright www.csmans.com
 
0.0079