Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: HVAC

Relay Replacement (Within an Electrical Center)
Special Tools EL-43244 Relay Puller Pliers Removal Procedure Remove the electrical center cover. Note: Always note the orientation of the relay. If equipped wi ...

General
...

Other materials:

Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto the balancer. The pilot bore (on the hub side of the wheel) is machined to be concentric to very tight non - standard tolerances. The bottom cap bore is not machined to this same degree of precision. Accurate mac ...

Timing Belt Installation
Special Tools EN-6333 Locking Pin EN-6340 Locking Tool For equivalent regional tools, refer to Special Tools. Note: The timing belt drive gear and oil pump housing must align. Turn the crankshaft in the direction of engine rotation, by the crankshaft balancer bolt ...

Neutral - Engine Running (Gen 2)
When the gear selector is moved to the Neutral (N) position, the hydraulic and electrical system operation is identical to Park (P) range. However, if Neutral is selected after the vehicle was operating in Reverse (R), the normally-low 35R pressure control solenoid is commanded OFF and the fol ...

В© 2014-2022 Copyright www.csmans.com
 
0.0105