Callout |
Component Name |
---|---|
Preliminary Procedures
|
|
1 |
Mode Control Cable Retaining Screw Caution: Refer to Fastener Caution.
1.2 Y (11 lb in) |
2 |
Mode Control Cable |
Immobilizer System Component Programming
This procedure will learn the immobilizer function. If the battery voltage is
low, charge the battery before proceeding with the learn. If the body control module
(BCM) or engine control module (ECM) have been replaced, they must be programmed
before performing this learn procedure.
Dependin ...
Strut and Shock Absorber Inspection
Note: The strut assembly DOES NOT have to be removed from the vehicle
to perform the following inspection procedure.
Note: A light film of oil on the top portion of the strut is normal.
DO NOT replace the strut for this condition.
Condition 1
Oil or fluid residue only o ...
Valve Lifter Replacement
Special Tools
EN-845 Suction Device
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the camshaft. Refer to Camshaft Replacement.
Note: Mark the assignments.
Remove the valve lifter (1) use the EN-845 suction device ...