Chevrolet Sonic Repair Manual: Electrical
- General
- Cruise Control Package Installation
- Door Lock and Ignition Lock Folding Key Blade Removal and Installation
- Electrical Center Identification Views
- Electrical Power Management Description and Operation
- Front Fog Lamp Package Installation
- Generator Pulley Replacement (LUV)
- Remote Control Door Lock, Theft Deterrent, and Remote Start Transmitter Package Installation
- SIR Disabling and Enabling
- Special Tools
- Starter Replacement (LUV)
- Starter Replacement (LUW)
- Starting System Description and Operation
- Battery System
- Battery Tray Replacement
- Battery Current Sensor Replacement
- Battery Charging
- Battery Description and Operation
- Battery Disconnect Warning
- Battery Inspection/Test
- Battery Negative Cable Disconnection and Connection
- Battery Negative Cable Replacement
- Battery Positive Cable Replacement
- Battery Positive and Negative Cable Replacement
- Battery Replacement
- Communication Interface Module Battery Replacement
- Charging
- Charging System Description and Operation
- Generator Installation
- Generator Removal
- Generator Replacement (LUV)
- Generator Replacement (LUW)
- Data and Communication Network
- Data Link Communications Description and Operation
- Body Control Module Programming and Setup
- Body Control Module Replacement
- Body Control System Description and Operation
- Fuses Junctions and Relays
Wheel Stud Replacement
Special Tools
CH 43631 Ball Joint Separator
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jackin ...
General
...
Other materials:
When the System Does Not Seem to Work Properly
The RVC system may not work properly or display a clear image if:
The RVC is turned off. See “Turning the Rear Camera System On or Off” earlier
in this section.
It is dark.
The sun or the beam of headlamps are shining directly into the camera lens.
Ice, snow, mud, or anything else b ...
Full-Cut Method Description
Note:
If corrosion of the pinch-weld flange is present, or if sheet metal
repairs or replacements are required, refinish the pinch-weld flange in
order to present a clean, primer-only surface.
If paint repairs are required, mask the flange bonding area, prior to
applying th ...
Transmission Control Lever Boot Replacement
Transmission Control Lever Boot Replacement
Callout
Component Name
Preliminary Procedure
Remove the front floor console. Refer to Front
Floor Console Replacement.
1
Shift Control Lever Knob Cove ...
0.0087