Chevrolet Sonic manuals

Audi Q7 (4M) 2016-2022 Owner's Manual: Electronic Stabilization Control

Description

Electronic Stabilization Control (ESC) supports driver safety. It reduces the risk of slipping and improves driving stability. ESC detects critical situations, such as if the vehicle is oversteering or understeering, or if the wheels are spinning.

The brakes are applied or the motor torque is reduced in order to stabilize the vehicle.

The following stabilization functions are integrated into the ESC, among others:

Anti-lock Braking System (ABS)

ABS prevents the wheels from locking when braking.

The vehicle can still be steered even during hard braking. Apply steady pressure to the brake pedal. Do not pump the pedal.

A pulsing in the brake pedal indicates that the system is acting to stabilize the vehicle.

Anti-Slip Regulation (ASR)

ASR reduces drive power when the wheels begin spinning and adapts the power to the road conditions.

This will increase the driving stability.

Electronic Differential Lock (EDL)

The EDL applies the brakes to wheels that are slipping and transfers the drive power to the other wheels. This function is not available at higher speeds.

In extreme cases, EDL automatically switches off to keep the brake on the braked wheel from overheating.

The vehicle is still functioning correctly.

EDL will switch on again automatically when conditions have returned to normal.

Selective wheel torque control

Selective wheel torque control is used when driving on curves. Braking is targeted toward the wheels on the inside of the curve as needed. This allows more precise driving in curves.

Power steering

The ESC can also support vehicle stability through steering.

WARNING

Tips

The ABS and ASR only function correctly when all four wheels have a similar wear condition.

Different tire sizes can lead to a reduction in motor power.

Operation

The button (or , depending on the model) for controlling the ESC is located in the center console, in front of the selector lever. The ESC is automatically switched on when the ignition is switched on.

Limiting ESC

In some situations, it may make sense to limit the stabilizing function of the ESC so that the wheels can spin, for example to rock a vehicle to free it when it is stuck or to drive with snow chains. The ESC can also be limited to provide more sporty driving characteristics with fewer stabilizing corrective actions.

Depending on the Audi drive select mode that is selected, one of the following ESC modes will be selected automatically:

Switching off ESC

For a more active control of the vehicle where the stabilizing functions of the ESC cannot intervene, the ESC can be switched off.

WARNING

Tips

Messages

The following messages may appear depending on the vehicle equipment:

Stabilization control (ESC/ ABS): malfunction! See owner's manual

There is a malfunction in the ABS or EDL. This also causes the ESC to malfunction. The brakes still function with their normal power, but ABS is not active.

Drive to an authorized Audi dealer or authorized Audi Service Facility immediately to have the malfunction corrected.

Other indicator lights

If blinks while driving, the ESC is actively regulating.

Operating noises may occur. If the indicator light stays on, the ESC has been switched off due to system needs. The indicator light turns off when the system is fully functional.

All wheel drive (quattro)
Description Applies to: vehicles with all wheel drive The all-wheel drive system distributes the driving power variably to the front and rear axle to improve the driving characteristics. It works to ...

Trailer
...

Other materials:

Center Pillar Lower Trim Panel Replacement
Center Pillar Lower Trim Panel Replacement Callout Component Name Preliminary Procedure Remove the front side door opening floor carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement. Remove ...

Fuel Pump Flow Control Module Replacement
Fuel Pump Flow Control Module Replacement Callout Component Name Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the right rear compart ...

2-6 Clutch Piston Installation (6T40/45/50)
2-6 Clutch Piston Installation Callout Component Name 1 2? Clutch Piston Assembly Note: Position the 2? piston air bleed and large slot toward the top of the case. DT-47796 seal protector pr ...

В© 2014-2022 Copyright www.csmans.com
 
0.0093