|
Callout |
Component Name |
|---|---|
Preliminary Procedure
|
|
|
1 |
Engine Coolant Fan Resistor Mount Procedure
Disconnect the electrical connections. |
Engine Coolant Fan Replacement (LUV)
Engine Coolant Temperature Sensor Replacement (Water Outlet)Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration
software. The module stores and utilizes this information however if it is not properly
configured with the correct calibration software, the seat heating control module
will not control all of the vehicle features ...
Secondary Air Injection Pump Pipe Replacement
Secondary Air Injection Pump Pipe Replacement
Callout
Component Name
1
Hose Retainer (QTY:2)
Note: Squeeze the retainer on opposite sides to release.
2
Secondary Air Injection ...
Front Wheel Drive Shaft Seal Replacement - Right Side
Front Wheel Drive Shaft Seal Replacement - Right Side
Callout
Component Name
Preliminary Procedures
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the front wheel drive shaft from the trans ...