Chevrolet Sonic Repair Manual: Information
- Coolant System Flushing
- Cooling System Description and Operation
- Cooling System Draining and Filling
- Engine Coolant Air Bleed Hose Replacement (LUV)
- Engine Coolant Fan Replacement (LDE/LUW)
- Engine Coolant Fan Replacement (LUV)
- Engine Coolant Fan Resistor Mount Repair
- Engine Coolant Temperature Sensor Replacement (Water Outlet)
- Engine Oil Cooler Coolant Inlet Hose Replacement (LUV)
- Engine Oil Cooler Inlet Pipe Replacement (LUW)
- Engine Oil Cooler Outlet Hose Replacement (LUV)
- Engine Oil Cooler Outlet Pipe Replacement (LUW)
- Engine Oil Cooler Pipe Replacement (LUW)
- Engine Oil Cooler Replacement
- Special Tools
- Throttle Body Heater Inlet Hose Replacement (LUW)
- Throttle Body Heater Inlet Pipe Replacement (LUW)
- Throttle Body Heater Outlet Hose Replacement (LUW)
- Throttle Body Heater Outlet Pipe Replacement (LUW)
- Turbocharger Coolant Feed Pipe Replacement (LUV)
- Turbocharger Coolant Return Pipe Replacement (LUV)
- Water Inlet Replacement (LUV)
- Water Inlet Replacement (LUW)
- Water Outlet Installation
- Water Outlet Removal
- Water Outlet Replacement (LUV)
Engine Cooling
...
Coolant System Flushing
Note:
Do not use a chemical flush.
Store used coolant in the proper manner, such as in a used engine coolant
holding tank.
Do not pour used coolant down a drain. Ethylene glycol a ...
Other materials:
Instrument Panel Outer Air Outlet Replacement - Right Side
Instrument Panel Outer Air Outlet Replacement - Right Side
Callout
Component Name
Preliminary Procedure
Remove the right instrument panel upper trim panel. Refer to Instrument
Panel Upper Trim Panel Replacement - Right Side ...
Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure
Remove the front wheel drive shaft inner joint and boot. Refer to Front
Wheel Drive Shaft Replacement.
Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3).
Remove the wheel drive shaft tripod housi ...
Engine Oil Cooler Assemble
Caution: Refer to Fastener Caution.
Install the engine oil filter cap (1) along with a NEW seal ring (2) and
a NEW oil filter element (3) and tighten to 25 Y (18 lb ft).
Install the engine oil pressure indicator switch (5) and ...
0.0096