Chevrolet Sonic Owner's Manual: Engine Exhaust
Warning
Engine exhaust contains carbon monoxide (CO) which cannot be seen or smelled. Exposure to CO can cause unconsciousness and even death.
Exhaust may enter the vehicle if:
- . The vehicle idles in areas with poor ventilation (parking garages, tunnels, deep snow that may block underbody airflow or tail pipes).
- . The exhaust smells or sounds strange or different.
- . The exhaust system leaks due to corrosion or damage.
- . The vehicle exhaust system has been modified, damaged, or improperly repaired.
- . There are holes or openings in the vehicle body from damage or aftermarket modifications that are not completely sealed.
If unusual fumes are detected or if it is suspected that exhaust is coming into the vehicle:
- . Drive it only with the windows completely down.
- . Have the vehicle repaired immediately.
Never park the vehicle with the engine running in an enclosed area such as a garage or a building that has no fresh air ventilation.
Engine Exhaust
...
Running the Vehicle While Parked
It is better not to park with the engine running.
If the vehicle is left with the engine running, follow the proper steps to be
sure the vehicle will not move. See Shifting Into Park (Automatic Tra ...
Other materials:
Exterior Lighting Systems Description and Operation
Exterior Lamps
The exterior lighting system consist of the following lamps if equipped:
Backup lamps
Front fog lamps
Hazard warning lamps
Headlamps
Park, tail and license lamps
Stop lamps
Turn signal lamps
Low Beam Headlamps
The body control module ...
Radio Rear Side Door Speaker Replacement
Radio Rear Side Door Speaker Replacement
Callout
Component Name
Preliminary Procedure
Remove the rear side door trim. Refer to Rear Side Door Trim Replacement.
1
Radio Rear Side Door Speaker Bolt ...
Drive Belt Installation
Special Tools
EN-955 Locking Pins
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Note: Ensure that the drive belt tensioner is held with EN-955?E
locking pin.
Install the drive belt.
Move the drive belt tensioner clockwise until EN- ...
0.0055