Chevrolet Sonic Owner's Manual: Engine Oil
To ensure proper engine performance and long life, careful attention must be paid to engine oil. Following these simple, but important steps will help protect your investment:
- Always use engine oil approved to the proper specification and of the proper viscosity grade. See “Selecting the Right Engine Oil” in this section.
- Check the engine oil level regularly and maintain the proper oil level. See “Checking Engine Oil” and “When to Add Engine Oil” in this section.
- Change the engine oil at the appropriate time. See Engine Oil Life System.
- Always dispose of engine oil properly. See “What to Do with Used Oil” in this section.
If the engine oil pressure light comes on, check the engine oil level right away. The oil pressure light is on the instrument cluster. See Engine Oil Pressure Light. Check the engine oil level regularly; this is an added reminder.
- Checking Engine Oil
- When to Add Engine Oil
- Selecting the Right Engine Oil
- Engine Oil Additives/Engine Oil Flushes
- What to Do with Used Oil
Engine Compartment Overview
1.4L L4 Engine
1. Engine Air Cleaner/Filter.
2. Engine Oil Dipstick. See Engine Oil.
3. Engine Cooling Fan (Out of View). See Cooling System.
4. Engine Oil Fill Cap. See Engine Oil.
5. Engine C ...
Checking Engine Oil
It is a good idea to check the engine oil level at each fuel fill. In order to
get an accurate reading, the oil must be warm and the vehicle must be on level ground.
The engine oil dipstick handle ...
Other materials:
Starting the Vehicle
1. Aim the RKE transmitter at the vehicle.
2. Press and release .
3. Immediately after completing Step 2, press and hold
for at least four seconds or until
the turn signal lamps flash.
When the engine starts, the parking lamps will turn on and remain on as long
as the engine is running. The ...
Shock Absorber Disposal
Warning: Use the proper eye protection when drilling to prevent metal
chips from causing physical injury.
Clamp the strut in a vise horizontally with the rod (1) completely extended.
Drill a hole in the strut at the center of the end cap (3) using a 5 mm
...
Main Shaft Disassemble (Gen 2)
Special Tools
69604356 Gear Pullers
For equivalent regional tools, refer to Special Tools.
Remove the 1st gear thrust washer (1) and the 1st gear (2)
using 69604356 pullersand a hydraulic press.
ii
Remove the following components:
1st gear bearing asse ...
0.0053