Chevrolet Sonic Repair Manual: Hood Ajar Indicator Description and Operation
- Hood Ajar Switch
-
The body control module (BCM) applies B+ to the hood ajar signal circuit and monitors the voltage to determine the position of the hood. When the hood is closed, the switch is open and voltage remains high. When the hood is open, the switch is closed and the voltage is pulled low.
The BCM uses the hood ajar switch as a content theft deterrent alarm trigger.
- Hood Ajar Indicator/Message
-
When the hood is ajar, a message is displayed on the DIC or the hood ajar indicator will be illuminated.
Hood Adjustment
Hood Adjustment
Callout
Component Name
1
Hood
Caution: Refer to Fastener Caution.
Procedure
Loosen t ...
Hood Hinge Replacement
Hood Hinge Replacement
Callout
Component Name
Preliminary Procedures
Remove the hood. Refer to Hood Replacement.
Remove the fr ...
Other materials:
Rear Compartment Lid Weatherstrip Replacement
Rear Compartment Lid Weatherstrip Replacement
Callout
Component Name
1
Rear Compartment Lid Weatherstrip
Procedure
Disconnect any electrical connector.
Clean the area where the seal will be mounted. Use a suit ...
Engine Front Cover and Oil Pump Assemble
Oil Pump Installation
Note: The oil pump slide spring and pin, as well as the slide
seal and slide seal spring can be ordered as single parts. All other
oil pump components can only be ordered as a replacement kit.
Install the oil pump components in the fo ...
Oil Pan Installation
Special Tools
EN-49980 Guidance Pins
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces from old sealing material, dirt, oil and grease.
Note: The sealing bead should be applied close to the inner edge
of the oil pan. Take care that the oil suctio ...
0.0066