
|
Callout |
Component Name |
|---|---|
|
1 |
Hood Rear Weatherstrip Procedure
The hood rear weatherstrip is held in place with 10?€‰plastic retainers that are part of the air inlet grille. Carefully pull the weatherstrip to the right/left to release from the retainers on the air inlet grille. |
Hood Rear Seal Replacement
Hood ReplacementNew Vehicle Break-In
Caution
The vehicle does not need an elaborate break-in. But it will perform better
in the long run if you follow these guidelines:
. Do not drive at any one constant speed, fast or slow, for the first
805 km (500 mi). Do not make full-throttle starts. Avoid downshifting to brake
or slo ...
Parking Brake Lever Replacement
Removal Procedure
Remove the front floor console. Refer to Front Floor Console Replacement.
Ensure that the park brake lever is in the fully released position.
Disconnect the electrical connector from the park brake warning lamp
switch.
Using ONLY HAND TOOL ...
Automatic Transmission Flex Plate Installation
Special Tools
EN-652 Automatic Transmission Flex Plate Holder
For equivalent regional tools, refer to Special Tools.
Clean the automatic transmission flex plate bolt threads.
Install the automatic transmission flex plate (2) and
the EN-652 holder to hold the automatic tran ...