Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the instrument panel center molding. Refer to Instrument Panel Center Molding Replacement. |
|
1 |
Instrument Panel Center Upper Molding Procedures
|
Trunk (Sedan)
Warning
Exhaust gases can enter the vehicle if it is driven with the liftgate, hatch/trunk
open, or with any objects that pass through the seal between the body and the hatch/trunk
or liftgate. Engine exhaust contains carbon monoxide (CO) which cannot be seen or
smelled. It can cause unconsci ...
Brake Fluid Level Indicator Switch Replacement
Removal Procedure
Disconnect the brake fluid level indicator switch
electrical connector.
Using a small, flat-bladed tool, lift the locking
tab on the underside of the brake fluid level indicator switch (1) and remove
the switch.
Inspect the maste ...
Throttle Body Assembly Installation
Install a NEW throttle body seal.
Install the throttle body (1).
Caution: Refer to Fastener Caution.
Install the 4 throttle body bolts (2) and tighten to
8 Y (71 lb in).
...