Chevrolet Sonic Owner's Manual: How to Reset the Engine Oil Life System
Reset the system whenever the engine oil is changed so that the system can calculate the next engine oil change. To reset the system:
1. Press the MENU button to show Remaining Oil Life on the display. This display shows an estimate of the oil’s remaining useful life. If 99% is displayed, that means that 99% of the current oil life remains.
2. To reset the engine oil life system, press the SET/CLR button while the oil life display is active. After a few seconds, there will be a single chime and the oil life will be reset to 100%.
Be careful not to reset the oil life display accidentally at any time other than after the oil is changed. It cannot be reset accurately.
If the 
%CHANGE message in the DIC
comes back on when the vehicle is started, the engine oil life system has not reset.
Repeat the procedure.
When to Change Engine Oil
This vehicle has a computer system that indicates when to change the engine oil
and filter. This is based on a combination of factors which include engine revolutions,
engine temperature, and mile ...
Automatic Transmission Fluid
How to Check Automatic Transmission Fluid
It is not necessary to check the transmission fluid level. A transmission fluid
leak is the only reason for fluid loss. If a leak occurs, take the vehicle ...
Other materials:
Brake Pipe Replacement
Special Tools
CH-45405 Brake Pipe Flaring Kit
For equivalent regional tools, refer to Special Tools.
Warning: Refer to Brake Fluid Irritant Warning.
Warning: Always use double walled steel brake pipe when replacing
brake pipes. The use of any other pipe is not recomm ...
Cylinder Head Assemble
Special Tools
EN-958 Valve Stem Seal Installer
EN-8062 Valve Spring Compressor
EN-8062-5 Adapter
EN-50717-2 Compressor Assembly of EN-50717 Kit
For equivalent regional tools, refer to Special Tools.
Lubricate the valve stem and the valve guide with clean engine oil.
...
Synchronizers Disassemble
1st/2nd Gear Synchronizer
iv
Note: When servicing the synchronizers, retain them in the
same order that they are removed. Keep the synchronizer components together
and mark them to identify correct location.
Remove the 1st/2nd gear synchronizer hub ...
0.005