How to Check Automatic Transmission Fluid
It is not necessary to check the transmission fluid level. A transmission fluid leak is the only reason for fluid loss. If a leak occurs, take the vehicle to your dealer and have it repaired as soon as possible.
There is a special procedure for checking and changing the transmission fluid. Because this procedure is difficult, you should have this done at your dealer.
Change the fluid and filter at the intervals listed in Maintenance Schedule , and be sure to use the fluid listed in Recommended Fluids and Lubricants.
ABS Description and Operation
This vehicle is equipped with the MGH 60 Mando electronic stability control antilock
brake system. The electronic brake control module and the brake pressure modulator
are serviced separately. The brake pressure modulator uses a four circuit configuration
to control hydraulic press ...
Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure
Remove the front wheel drive shaft inner joint and boot. Refer to Front
Wheel Drive Shaft Replacement.
Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3).
Remove the wheel drive shaft tripod housi ...
Engine Flywheel Installation
Special Tools
EN-652 Flywheel Holder
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools.
Clean the thread in the crankshaft.
Install the crankshaft position reluctor ring (1).
Install the flywheel (2).
Install the EN-652 ...