Callout |
Component Name |
---|---|
1 |
Fluid Pump Seal Assembly |
2 |
Torque Converter Housing Gasket |
3 |
Torque Converter (w/Fluid Pump) Housing Assembly Note: Rotate the differential slightly in each direction using the rotating tool to align the Differential Pinion Gears with the Differential Ring Gear in the Torque Converter Housing.
For equivalent regional tools, refer to Special Tools. |
4 |
Torque Converter and Differential Housing Bolts M8 x 30 (Qty: 15) Caution: Refer to Fastener Caution. Procedure
Tighten the bolts in sequence shown. Tighten
10 Y (89 lb in) then rotate the bolt an additional 50 degrees Special Tool
EN-45059 Angle Meter or equivalent For equivalent regional tools, refer to Special Tools. |
Evaporative Emission Canister Replacement (Steel Tank)
Removal Procedure
Remove the evaporative emission canister bracket fasteners (1).
Disconnect the purge solenoid valve electrical connector (1).
Disconnect the evaporative emission canister vent hose (2).
Disconnect the evaporative emission c ...
Oil Pump Cleaning and Inspection
Remove the external rotor with the internal rotor.
Visually inspect the components.
Install the external and the internal rotors.
Inspect the axial clearance of the rotors in respect to the control unit
housing upper edge.
Specifications
Permissible measurement is 0.02?E.058 ...
Torque Converter Housing with Fluid Pump Assembly Removal (Non Hybrid)
Torque Converter Housing with Fluid Pump Assembly Removal
Callout
Component Name
1
Torque Converter and Differential Housing Bolts M8 x 30 (Qty: 15)
2
Torque Conv ...