|
System |
DTCs Required to Set System Status to YES |
|---|---|
|
If an inspection/maintenance system status indicator did NOT update to YES during the Inspection/Maintenance System Check, review each indicator and reference this table to determine each DTC associated with the inspection/maintenance system status indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs which, if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the conditions for running for each DTC listed below will allow the inspection/maintenance system status indicators to transition to YES. |
|
|
AIR |
|
|
Catalyst Monitor |
DTC P0420 |
|
Evaporative emission (EVAP) |
|
|
Fuel System |
DTC P219A |
|
Oxygen sensor |
|
|
Oxygen sensor heater |
DTC P0030-P0032, P0036-P0038, P0053, P0054, P0135, or P0141 |
|
Camshaft System |
DTC P0011 or P0014 |
Inspection/Maintenance (I/M) System DTC Table (LUW)
Inspection/Maintenance Complete System Set ProcedureCommunication Interface Module Bracket Replacement
Communication Interface Module Bracket Replacement
Callout
Component Name
Preliminary Procedure
Remove the instrument panel lower compartment. Refer to
Instrument Panel Lower Compartment Replacement
1
...
Sunroof Window Height and Opening Fit Adjustment
Note: Correct adjustment cannot be achieved if the sunroof window
is closed from vent position.
Cycle the sunroof window from full open to closed position.
.,
Note: Do Not remove or lower headliner to access sunroof window
screws.
Loosen the adjusting screws on ...
Fuel Tank Fuel Pump Module Replacement (Steel Tank)
Special Tools
EN-48279 Fuel Sender Lock Ring Wrench
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Relieve the fuel system pressure. Refer to Fuel Pressure Relief.
Remove the fuel tank. Refer to Fuel Tank Replacement.
Disconnect the ...