|
System |
DTCs Required to Set System Status to YES |
|---|---|
|
If an inspection/maintenance system status indicator did NOT update to YES during the Inspection/Maintenance System Check, review each indicator and reference this table to determine each DTC associated with the inspection/maintenance system status indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs which, if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the conditions for running for each DTC listed below will allow the inspection/maintenance system status indicators to transition to YES. |
|
|
Catalyst Monitor |
DTC P0420 |
|
Evaporative emission (EVAP) |
|
|
Fuel System |
DTC P219A |
|
Oxygen sensor |
|
|
Oxygen sensor heater |
DTC P0030-P0032, P0036-P0038, P0053, P0054, P0135, or P0141 |
|
Camshaft System |
DTC P0011 or P0014 |
Inspection/Maintenance (I/M) System DTC Table
Inspection/Maintenance (I/M) System DTC Table (LWE)Battery Positive and Negative Cable Replacement
Removal Procedure
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove the fuse block and battery positive cable cover.
Remove the battery tray. Refer to Battery Tray Replacement.
Remove the battery posit ...
Warm Up Three-Way Catalytic Converter Replacement (LUV,LUW)
Warm Up Three-Way Catalytic Converter Replacement
Callout
Component Name
Warning: Refer to Exhaust Service Warning.
Warning: Refer to Safety Glasses Warning.
Preliminary Procedure
Raise and support the ...
Internal Components Removal
Internal Components Removal
Callout
Component Name
1
1??? Clutch Backing Plate Retainer Ring
Warning: The retainer is under tension. Use care when removing
or installing the retainer. Personal injury could r ...