Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Liftgate Hinge Replacement



Liftgate Hinge Replacement

Callout

Component Name

Preliminary Procedures

  1. Remove the liftgate. Refer to Liftgate Replacement.
  2. Lower the rear of the headliner to access the inner bolts. Refer to Headlining Trim Panel Replacement.
  3. Use a grease pencil to mark the liftgate hinge position to the body prior to removal.

1

Liftgate Hinge Nut (Qty:?€‰2)

Caution:

Refer to Fastener Caution.

Tighten


43?€‰Y (32?€‰lb?€‰ft)

2

Liftgate Hinge (Qty:?€‰2)

Procedure

Adjust the liftgate if needed.

Liftgate Window Replacement
Special Tools BO-24402-A Glass Sealant Remover (Cold Knife) BO-39032 Stationary Glass Removal Tool Use an adhesive that is approved by GM For equivalent regional tools, refer to Special Too ...

Body Exterior
...

Other materials:

Front Floor Console Extension Replacement - Left Side
Front Floor Console Extension Replacement - Left Side Callout Component Name 1 Front Floor Console Extension Push-In Retainer 2 Front Floor Console Extension Procedure Use a flat bladed ...

SIR Service Precautions
General Service Instructions Warning: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, person ...

2-6 Clutch Piston Installation (6T30)
2-6 Clutch Piston Installation Callout Component Name 1 2?E Clutch Piston Assembly Note: Position the 2?E piston air bleed and large slot toward the top of the case. DT-48271 seal protector ...

© 2014-2026 Copyright www.csmans.com
 
0.0078