Chevrolet Sonic Owner's Manual: Power Door Locks
Select Power Door Locks and the following may display:
- Auto Door Unlock
- Unlock Door Anti Lock Out
- Delayed Door Lock
Auto Door Unlock
This allows selection of which of the doors will automatically unlock when the vehicle is shifted into P (Park) or the key is removed.
Select All Doors, Driver Door, or Off.
Unlock Door Anti Lock Out
When on, this feature will keep the driver door from locking when the door is open. If off is selected, the Unlock Door Anti Lock Out menu will be available and the door will lock as programmed through this menu.
Select On or Off.
Delayed Door Lock
When on, this feature will delay the locking of the doors until five seconds after the last door is closed. Three chimes will signal that delayed locking is in use. Pressing will override the delayed locking feature and immediately lock all of the doors.
Select On or Off.
Exterior Lighting
Select the Lighting menu and the following may display:
Exterior Vehicle Locator Lights
Exit Lighting
Exterior Vehicle Locator Lights
This allows selection of whether the exterior lamps will ...
Remote Lock, Unlock, Start
Select Remote Lock, Unlock, Start and the following may display:
Remote Unlock Feedback
Remote Lock Feedback
Remote Door Unlock
Remote Unlock Feedback
When on, the exterior lamps will flas ...
Other materials:
Rear Brake Hose Replacement (Body to Axle - Disc Brake)
Removal Procedure
Warning: Refer to Brake Dust Warning.
Warning: Refer to Brake Fluid Irritant Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Install ...
Heater and Air Conditioning Evaporator and Blower Module Removal and Installation
Heater and Air Conditioning Evaporator and Blower Module Removal and
Installation
Callout
Component Name
Preliminary Procedures
Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
Drain the cooling sy ...
Heater and Air Conditioning Control Replacement
Heater and Air Conditioning Control Replacement
Callout
Component Name
Preliminary Procedures
Remove I/P center bezel. Refer to Instrument Panel Center Molding
Replacement.
Remove front floor shifter bezel. Refer to Front ...
0.0045