Chevrolet Sonic Repair Manual: Rear Seat Shoulder Belt Guide Opening Bezel Replacement
|
Callout |
Component Name |
|---|---|
|
1 |
Rear Seat Shoulder Belt Opening Bezel Procedure
Push inward and upward from the front of the bezel to release from the seat back. Note: The rear seat shoulder belt opening bezel is part of the rear seat center belt assembly and is replaced as an assembly. |
Rear Seat Head Restraint Replacement
Rear Seat Head Restraint Replacement
Callout
Component Name
1
Rear Seat Head Restraint
Preliminary Procedures
Dep ...
Seat Adjustment
Manual Seats
To adjust a manual seat:
Pull the handle at the front of the seat.
Slide the seat to the desired position and release the handle.
Try to move the seat back and for ...
Other materials:
Engine Block Cleaning and Inspection
Special Tools
EN-8087 Cylinder Gauge
For equivalent regional tools, refer to Special Tools.
Clean the sealing material from the gasket mating surfaces (2).
Clean the engine block (1) and lower crankcase in a cleaning tank with solvent
appropriate for aluminum. Refer ...
Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the cylinder head.
Disconnect the ignition coil electrical connector (2).
...
Turbocharger Removal
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Install the EN-49942 holding wrench (2) to the turbocharger coolant
feed pipe. Guide a ratchet wrench (1) along with an extension through EN-49942
holding wrench to the turbo ...
0.0056