Chevrolet Sonic Repair Manual: Rear Wheelhouse Liner Replacement (Sedan - Right)
|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. |
|
|
1 |
Rear Wheelhouse Panel Liner Screw (Qty:?€‰4) Caution: Refer to Fastener Caution.
3?€‰Y (27?€‰lb?€‰in) |
|
2 |
Rear Wheelhouse Panel Liner Nut (Qty:?€‰4) Tighten
2?€‰Y (18?€‰lb?€‰in) |
|
3 |
Rear Wheelhouse Panel Liner Push-In Retainer |
|
4 |
Rear Wheelhouse Panel Liner |
Rear Wheelhouse Liner Replacement (Sedan - Left)
Rear Wheelhouse Liner Replacement
Callout
Component Name
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tir ...
Trunk Bed
...
Other materials:
Brake Fluid Level Indicator Switch Replacement
Removal Procedure
Disconnect the brake fluid level indicator switch electrical connector.
Using a small, flat-bladed tool, lift the locking tab on the underside
of the brake fluid level indicator switch (1) and remove the switch.
Inspect the master cyli ...
Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange,
remeasure the tire and wheel assembly on-vehicle runout in order to verify that
the amount of runout has been reduced and brought to within tolerances.
Mark the location of the high spot on the tire and wheel asse ...
Tire and Wheel Assembly Balancing - On-Vehicle
Special Tools
EL-38792-A Electronic Vibration Analyzer (EVA) 2
If after following the tire and wheel vibration diagnostic process, some amount
of tire and wheel vibration is still evident, an on-vehicle high-speed spin balancer
may be used to perform an on-vehicle balance in an attempt ...
0.0053