Chevrolet Sonic Owner's Manual: Retained Accessory Power (RAP)
These vehicle accessories may be used for up to 10 minutes after the engine is turned off:
- Audio System
- Power Windows
- Sunroof
The power windows and sunroof will continue to work for up to 10 minutes or until any door is opened.
The radio will work when the key is in ON/RUN or ACC/ACCESSORY. Once the key is turned from ON/ RUN to LOCK/OFF, the radio will continue to work for 10 minutes after the last input (button press, knob turn) to the radio is detected.
It is possible to turn the radio back on at any time after it has timed out using the Power knob. The radio will be functional for 10 minutes after the last input (button press, knob turn) to the radio is detected.
Engine Heater
The engine heater can provide easier starting and better fuel economy during
engine warm-up in cold weather conditions at or below −18°C (0°F). Vehicles with
an engine heater should be plu ...
Shifting Into Park (Automatic Transmission)
1. Hold the brake pedal down and set the parking brake. See Parking Brake.
2. Move the shift lever into P (Park) by pressing the button on the shift lever
and pushing the lever all the way toward t ...
Other materials:
Front Floor Console Extension Replacement - Right Side
Front Floor Console Extension Replacement - Right Side
Callout
Component Name
1
Front Floor Console Extension
Procedure
Use a flat bladed plastic trim tool in order to release the retainers
securing the extens ...
Brake Drum Surface and Wear Inspection
Special Tools
CH-8001 Dial Indicator Set
For equivalent regional tools, refer to Special Tools.
Warning: Refer to Brake Dust Warning.
With the brake drum removed, clean the brake shoe lining contact surface
of the brake drum with denatured alcohol or an equivalent approved brak ...
Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should
be performed before replacing the bushing, shaft, and in some cases, the component
which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces
before inspecting for damage.
Any of the followin ...
0.0049