Warning:
After deployment, the metal surfaces of the SIR component may be very hot. To help avoid a fire or personal injury:
Secondary
SIR Disabling and EnablingHeadlamp Aiming
Visual Aiming Preparation Procedure
Note: Some state and local laws specify requirements for headlamp
aim. Comply with all of these laws when performing any headlamp aiming operations.
Headlamp aim should be checked:
When a new headlamp capsule is installed.
If ser ...
Front Seat Belt Guide Adjuster Replacement (with AHU)
Front Seat Belt Guide Adjuster Replacement
Callout
Component Name
Preliminary Procedures
Remove the center pillar upper trim panel. Refer to Center Pillar Upper
Trim Panel Replacement.
1
Driver ...
Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral
(N) position, the transmission will provide engine braking. In this operating range,
the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine
braking mode, the following changes occur with ...