Chevrolet Sonic Owner's Manual: Tire Chains
Warning
Do not use tire chains. There is not enough clearance. Tire chains used on a vehicle without the proper amount of clearance can cause damage to the brakes, suspension, or other vehicle parts. The area damaged by the tire chains could cause loss of control and a crash.
Use another type of traction device only if its manufacturer recommends it for the vehicle's tire size combination and road conditions. Follow that manufacturer's instructions. To avoid vehicle damage, drive slow and readjust or remove the traction device if it contacts the vehicle. Do not spin the wheels. If traction devices are used, install them on the front tires.
Used Replacement Wheels
Warning
Replacing a wheel with a used one is dangerous. How it has been used or how
far it has been driven may be unknown. It could fail suddenly and cause a crash.
When replacing wheels, use a n ...
If a Tire Goes Flat
It is unusual for a tire to blow out while driving, especially if the tires are
maintained properly. See Tires. If air goes out of a tire, it is much
more likely to leak out slowly. But if there i ...
Other materials:
Keys
Warning
Leaving children in a vehicle with a Remote Keyless Entry (RKE) transmitter
is dangerous and children or others could be seriously injured or killed. They could
operate the power windows or other controls or make the vehicle move. The windows
will function with the RKE transmitter in ...
Making a Call Using Phone Book
For cell phones that support the phone book feature, the Bluetooth system can
use the contacts stored on your cell phone to make calls. See your cell phone's
owner's guide or contact your wireless provider to find out if this feature is supported
by your phone.
When a cell phone suppo ...
Dimensions - Body (5HB)
Point-to-point measurements are for reference only. All measurements are given
in millimeters. Use these measurements for diagnosing and estimating. Point-to-point
measurements are duplicated with tram bar pointers set at equal lengths. All die
marks, holes, slots, and fasteners are measured t ...
0.0072