Chevrolet Sonic Owner's Manual: Tire Changing

Storing the Tire Sealant and Compressor Kit

The tire sealant and compressor kit is located in the rear storage area. 1. Lift the trim cover. 2. Remove the tire sealant canister (1) and the compressor (2). To store the tire sealant canister ...

Removing the Spare Tire and Tools

The compact spare tire and tools are located in the storage compartment in the rear of the vehicle. The jack and tools are stored below the spare tire. 1. Extension 2. Jack 3. Wheel Wrench 4. ...

Other materials:

Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
Special Tools EL-49642 SPS Programming Support Tool For equivalent regional tools, refer to Special Tools. Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the ECU is not properly configured with the correct calibration ...

SIR Service Precautions
General Service Instructions Warning: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, person ...

Water Pump Pulley Installation
Note: Counterhold the crankshaft balancer. The belt has to be installed for this procedure. Install the water pump pulley (2) to the water pump (3). Caution: Refer to Fastener Caution. Install the 3 water pump pulley bolts (1) with lockin ...