Chevrolet Sonic Repair Manual: Tire Dismounting and Mounting (Match Mounting)
- Match mounting is required on any wheel/tire assembly not within RFV specification.
- All wheel weights should be removed prior to match mounting.
- Match mounting is required on any assembly where the RFV readings are out of spec.
- Match mounting identified in the high spot of the tire and matches it with the low spot on the rim.
- Marks must be aligned +/- 25mm PRIOR to inflation.
Important:
If a wheel/tire assembly is not within the RFV specification after match mounting, the tire must be returned to the tire manufacturer.
Tire Dismounting and Mounting (Lubricant)
Important:
Lubricant should be applied to form a thin, just visible layer,
on the bead foot and bead outer areas. There should not be any visible
clumps of lubricant.
Ne ...
Tire Inflation Description
When you inflate the tires to the recommended inflation pressures, the factory-installed
wheels and tires are designed in order to handle loads to the tire's rated load
capacity. Incorrect tir ...
Other materials:
Tire Rotation and Required Services Every 12 000 km/ 7,500 mi
Rotate the tires, if recommended for the vehicle, and perform the following services.
See Tire Rotation.
Check engine oil level and oil life percentage. If needed, change engine
oil and filter, and reset oil life system. See Engine Oil and Engine
Oil Life System.
Check engine coo ...
Rear Side Door Window Switch Replacement
Rear Side Door Window Switch Replacement
Callout
Component Name
Preliminary Procedure
Remove the rear side door window switch bezel. Refer to Rear Side Door
Window Switch Bezel Replacement.
1
Re ...
Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
0.0056