Chevrolet Sonic Repair Manual: Brake Rotors

Rear Disc Brake Pads Replacement

Removal Procedure Warning: Refer to Brake Dust Warning. Note: Always replace disc brake pads in axle sets. Inspect the fluid level in the brake master cylinder reservo ...

Brake Rotor Assembled Lateral Runout Correction

Note: Brake rotor thickness variation MUST be checked BEFORE checking for assembled lateral runout (LRO). Thickness variation exceeding the maximum acceptable level can cause brake p ...

Other materials:

Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the seat heating control module will not control all of the vehicle features ...

Piston, Connecting Rod, and Bearing Removal
Install the crankshaft balancer bolt. Set the pistons 1 and 4 to TDC in direction of engine rotation. Note: Note cylinder sequence. Mark the connecting rod with the connecting rod bearing cover (1). Remove the 4 connecting rod bearing caps bol ...

Reverse (Gen 1)
When the gear selector lever is moved to the Reverse (R) position (from the Park position) the normally-high 35R pressure control solenoid 2 is commanded ON and the following changes occur in the transmission? hydraulic and electrical systems: 3-5-Reverse Clutch Applies Manual Valv ...