Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Automatic Headlamp System

When it is dark enough outside and the exterior lamp control is in the automatic position, the headlamps come on automatically. See Exterior Lamp Controls.

The vehicle has a light sensor on top of the instrument panel. Make sure it is


The vehicle has a light sensor on top of the instrument panel. Make sure it is not covered, or the headlamps will be on when they are not needed.

The system may also turn on the headlamps when driving through a parking garage or tunnel.

Lights On with Wipers

If the windshield wipers are activated in daylight with the engine on, and the exterior lamp control is in AUTO, the headlamps, parking lamps, and other exterior lamps come on. The transition time for the lamps coming on varies based on wiper speed. When the wipers are not operating, these lamps turn off. Move the exterior lamp control to to disable this feature. or
Hazard Warning Flashers to disable this feature.


Daytime Running Lamps (DRL)
DRL can make it easier for others to see the front of your vehicle during the day. Fully functional DRL are required on all vehicles first sold in Canada. This indicator light turns on in the ins ...

Hazard Warning Flashers
(Hazard Warning Flasher): Press and momentarily hold this button to make the front and rear turn signal lamps flash on and off. This warns others that you are having trouble. Press and momentar ...

Other materials:

Windshield Upper Reveal Molding Replacement
Windshield Upper Reveal Molding Replacement Callout Component Name Preliminary Procedures Remove the windshield to replace the reveal molding. Refer to Windshield Replacement. 1 Windshield Revea ...

Brake Rotor Thickness Variation Measurement
Warning: Refer to Brake Dust Warning. Note: Any disc brake rotor that exhibits thickness variation exceeding the maximum acceptable level must be refinished or replaced. Thickness variation exceeding the maximum acceptable level can cause brake pulsation. If the inboard fricti ...

Neutral - Engine Running (Gen 2)
When the gear selector is moved to the Neutral (N) position, the hydraulic and electrical system operation is identical to Park (P) range. However, if Neutral is selected after the vehicle was operating in Reverse (R), the normally-low 35R pressure control solenoid is commanded OFF and the fol ...

В© 2014-2025 Copyright www.csmans.com
 
0.0081