Replacing Airbag System Parts after a Crash
Older ChildrenLock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1?E. The ignition cylinder
tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in
and are not self-retaining. It follows the key code with the first tumbler being
the first depth of the ke ...
Input Shaft Support Replacement (Gen 1)
Input Shaft Support Replacement
Callout
Component Name
1
3-5 Reverse and 4-5-6 Clutch Fluid Seals (Qty: 4)
Note:
Discard the fluid seals. They are not reusable.
Refer to 3-5-Reverse an ...
Main Shaft Disassemble (Gen 2)
Special Tools
69604356 Gear Pullers
For equivalent regional tools, refer to Special Tools.
Remove the 1st gear thrust washer (1) and the 1st gear (2)
using 69604356 pullersand a hydraulic press.
ii
Remove the following components:
1st gear bearing asse ...