Note:
The crankshaft position sensor system variation learn procedure is required when the following service procedures have been performed, regardless of whether DTC P0315 is set:
Note:
The ECM monitors certain component signals to determine if all the conditions are met to continue with the Crankshaft Position Variation Learn procedure.
Charge Air Cooler Replacement
Electronic Ignition System DescriptionAir Inlet Valve Actuator Replacement (LHD)
Air Inlet Valve Actuator Replacement
Callout
Component Name
Preliminary Procedures
Remove the instrument panel compartment. Refer to Instrument Panel
Lower Compartment Replacement.
Reposition any wiring or hoses to gain a ...
Engine Block Cleaning and Inspection
Special Tools
EN-8087 Cylinder Gauge
For equivalent regional tools, refer to Special Tools.
Clean the sealing material from the gasket mating surfaces (2).
Clean the engine block (1) and lower crankcase in a cleaning tank with solvent
appropriate for aluminum. Refer ...
Timing Belt Lower Front Cover Replacement
Timing Belt Lower Front Cover Replacement
Callout
Component Name
Preliminary Procedures
Remove the front wheelhouse liner inner front extension. Refer to
Front Wheelhouse Liner Inner Front Extension Replacement.
Remove th ...