Callout |
Component Name |
---|---|
Preliminary Procedure
|
|
1 |
Engine Coolant Temperature Sensor Fastener |
2 |
Engine Coolant Temperature Sensor Procedure
Disconnect the electrical wiring harness connector from the engine coolant temperature sensor. |
Front Wheel Drive Shaft Seal Replacement - Left Side
Special Tools
DT-446 Installer Drift
DT-7004 Slide Hammer
DT-23129 Universal Seal Remover
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the front suspension sk ...
Positive Crankcase Ventilation Hose/Pipe/Tube Replacement
Removal Procedure
Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct
Replacement.
Open the 2 positive crankcase ventilation pipe retainer clips (2) and (3).
Note: Move retainer clamp (1) in direction of the arrow. ...
Front Floor Console Cover Replacement (Manual Transmission)
Removal Procedure
Use a flat bladed plastic trim tool in order to release
the retainers securing the console cover (1) to the console assembly.
Reach under the console cover assembly (1) and release
the retainer tabs securing the transmission s ...