Chevrolet Sonic Repair Manual: Front Side Door Weatherstrip Replacement - Body Side

Chevrolet Sonic Repair Manual / Body / Body Exterior / Weatherstripping / Front Side Door Weatherstrip Replacement - Body Side

Front Side Door Weatherstrip Replacement - Body Side
Callout	Component Name
Preliminary Procedures Remove the upper center pillar trim. Refer to Center Pillar Upper Trim Panel Replacement. Remove the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement Remove the carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement.
1	Front Side Door Weatherstrip Body Side Procedure Starting in the center bottom of the weatherstrip, pull the weatherstrip upward and away from the pinch-weld flange. Start in the center bottom of the pinch-weld flange. Ensure that the weatherstrip and retainers are fully seated on the flange before installing the front carpet retainer. Inspect the door for proper operation.

Weatherstripping

...

Front Side Door Weatherstrip Replacement - Door Side

Front Side Door Weatherstrip Replacement - Door Side Callout Component Name 1 Front Side Door Weatherstrip Upper Retaine ...

Other materials:

If No Steam Is Coming from the Engine Compartment
If an engine overheat warning is displayed but no steam can be seen or heard, the problem may not be too serious. Sometimes the engine can get a little too hot when the vehicle: Climbs a long hill on a hot day. Stops after high-speed driving. Idles for long periods in traffic. If the ...

Front Brake Shield Replacement
Removal Procedure Warning: Refer to Brake Dust Warning. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Remove the front brake rotor. Refer to ...

Camshaft Installation
Special Tools EN-422 Installer For equivalent regional tools, refer to Special Tools. Note: Coat with MoS 2 lubricating paste. Refer to Adhesives, Fluids, Lubricants, and Sealers. Install the intake camshaft (1). Note: Note the identification mark ...

0.0264