Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Front Side Door Window Replacement

Chevrolet Sonic Repair Manual / Body / Glass & Windows / General / Front Side Door Window Replacement



Front Side Door Window Replacement

Callout

Component Name

Warning:

Refer to Glass and Sheet Metal Handling Warning.

Preliminary Procedures

  1. Remove the front side door trim panel. Refer to Front Side Door Trim Replacement.
  2. Remove the front side door rear guide. Refer to Front Side Door Window Rear Guide Replacement
  3. Remove the front side door window outer sealing strip. Refer to Front Side Door Window Outer Sealing Strip Replacement.

1

Front Side Door Window Regulator Guide Nuts?€‰(Qty:?€‰2)

Caution:

Refer to Fastener Caution.

Procedure

  1. Use masking tape, tape off the outer door frame and applique to prevent scratching.
  2. Remove the front side door water deflector.
  3. Loosen nuts so that the window can be removed from the guides.
  4. In order to remove the window out of the frame, carefully grasp and tilt the window as you guide the window up and forward.
Tighten


11?€‰Y?€‰(97?€‰lb?€‰in)

2

Front Side Door Window

Procedure

  1. Lower the window to align the guide nuts with the access holes in the inner door panel.
  2. Do not operate the regulator motor without supporting the window. Ensure that the window remains in the guide when operating the regulator motor.
  3. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the guide.
  4. Inspect the window for proper operation before installing the trim panel.
Front Side Door Window Rear Guide Replacement
Front Side Door Window Rear Guide Replacement Callout Component Name Preliminary Procedure Remove the front side door trim pane ...

Front Side Door Window Weatherstrip Replacement
Front Side Door Window Weatherstrip Replacement Callout Component Name Preliminary Procedures Remove front side door trim panel. Re ...

Other materials:

SIR Inflator Module Handling and Storage Warning
Warning: When carrying an undeployed inflator module: Do not carry the inflator module by the wires or connector. Make sure the air bag opening points away from you. When storing an undeployed inflator module: Make sure the air bag opening points away from the surface o ...

Body Control Module Programming and Setup
Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the control module is not properly configured with the correct calibration software, the control module will not control all of the vehicle features properly. Ensure th ...

Control Valve Body Assembly Installation
Control Valve Body Assembly Installation Callout Component Name 1 Low and Reverse Clutch Fluid Passage Seal 2 1-2-3-4 Clutch Fluid Passage Seal 3 Control Valve Body ...

© 2014-2026 Copyright www.csmans.com
 
0.0055