Chevrolet Sonic Repair Manual: Headlamp Aiming
Headlamp aim has been preset and should need no further adjustment.
If the vehicle is damaged in a crash, the headlamp aim may be affected. If adjustment to the headlamps is necessary, see your dealer.
Headlamp Aiming
Visual Aiming Preparation Procedure
Note: Some state and local laws specify requirements for headlamp
aim. Comply with all of these laws when performing any headlamp aiming operations ...
Headlamp Bracket Replacement
Headlamp Bracket Replacement
Callout
Component Name
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper ...
Other materials:
Battery Current Sensor Replacement
Removal Procedure
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Disconnect the battery current sensor from the body harness connector.
Unclip the battery current sensor from the battery tray.
Remove the battery ...
Battery Tray Replacement
Battery Tray Replacement
Callout
Component Name
Preliminary Procedures
Remove the battery. Refer to Battery Replacement.
Unclip the engine control module (ECM) bracket from the battery
tray and set aside.
Unclip the ...
Fuel Pump Control Module Programming and Setup
The fuel pump control module must be programmed with the proper calibration software.
The module stores and utilizes this information however if it is not properly configured
with the correct calibration software, the fuel pump control module will not control
all of the vehicle features proper ...
0.0063