Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Ignition Coil Removal

Special Tools

EN-6009 Remover and Installer Ignition Module

For equivalent regional tools, refer to Special Tools.


    Remove the 2 ignition coil bolts (1).
  1. Remove the 2 ignition coil bolts (1).

  2. Install EN-6009 remover and installer  (2) and remove the ignition coil (1).
Ignition Coil Installation
Special Tools EN-6009 Remover and Installer Ignition Module For equivalent regional tools, refer to Special Tools. Install the ignition coil (1) and remove EN-6009 remover and ins ...

Ignition Coil Replacement
Special Tools EN-6009 Remover and Installer Ignition Coil For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the engine wiring harness guideR ...

Other materials:

Sunroof Window Seal Replacement
Removal Procedure Remove the sunroof window panel. Refer to Sunroof Window Replacement. Remove the seal from the window panel frame by pulling the seal away at one point and continuing around the perimeter of the frame. Clean around the edge of the inside surf ...

Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the seat heating control module will not control all of the vehicle features ...

Cleanliness and Care
An automobile engine is a combination of many machined, honed, polished, and lapped surfaces with tolerances that are measured in ten thousandths of an inch. When any internal engine parts are serviced, care and cleanliness are important. A liberal coating of engine oil should be applied to fr ...

В© 2014-2026 Copyright www.csmans.com
 
0.0056