While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position.
On all vehicles, the ignition key should come out only in LOCK/OFF.
Contact your dealer if service is required.
Electronic Ignition System Description
Ignition and Start Switch Housing ReplacementWheel Alignment and Tire Balance
The tires and wheels were aligned and balanced at the factory to provide the
longest tire life and best overall performance. Adjustments to wheel alignment and
tire balancing are not necessary on a regular basis. Consider an alignment check
if there is unusual tire wear or the vehicle is signi ...
Air Conditioning Compressor and Condenser Hose Replacement (LDE/LWE)
Removal Procedure
Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
Disconnect the A/C refrigerant pressure sensor electrical connector.
Remove air conditioning compressor and condenser hose nut (1).
Remove air conditioning compressor and ...
Drive Belt Installation
Special Tools
EN-955 Locking Pins
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Note: Ensure that the drive belt tensioner is held with EN-955?E
locking pin.
Install the drive belt.
Move the drive belt tensioner clockwise until EN- ...