While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position.
On all vehicles, the ignition key should come out only in LOCK/OFF.
Contact your dealer if service is required.
Transmission Adaptive FunctionsBackup Lamp Switch Replacement
Removal Procedure
Disconnect the electrical connector from the backup lamp switch?€‰(1).
Remove the backup lamp switch?€‰(1) from the transmission.
Remove and DISCARD the backup lamp switch washer from the backup lamp
switch.
Installation Proc ...
Hood Insulator Replacement
Hood Insulator Replacement
Callout
Component Name
1
Hood Insulator Plastic Retainer (Qty:?€‰6)
2
Hood Insulator
Procedure
Ensure the 3 integral tabs are secured to the hood.
...
Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools.
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the ECU is not properly configured with the correct
calibration ...