Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the instrument panel center molding. Refer to Instrument Panel Center Molding Replacement. |
|
1 |
Instrument Panel Accessory Upper Trim Plate Fastener (Qty:?€‰4) Caution: Refer to Fastener Caution. |
2 |
Instrument Panel Accessory Upper Trim Plate (Qty:?€‰2) Procedures
|
Engine Heater
The engine heater can provide easier starting and better fuel economy during
engine warm-up in cold weather conditions at or below −18°C (0°F). Vehicles with
an engine heater should be plugged in at least four hours before starting.
1. Turn off the engine.
2. Open the hood and unwrap ...
Door Lock and Ignition Lock Folding Key Blade Removal and Installation
Special Tools
BO-51098 Flip Key Blade Fixture
For equivalent region tools, refer to Special Tools.
Caution: Failure to properly support the Remote Keyless Entry
(RKE) transmitter assembly while replacing the key blade may cause internal
damage to the transmitter assembly. ...
Engine Block Disassemble
Remove the cylinder head locating (1, 2).
Remove the oil pressure switch (1).
Remove the knock sensor bolt (2) and the knock sensor (1).
Clean the thread.
Remove the oil flow check valve (1).
Remove the oil pressure rel ...