|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the instrument panel center molding. Refer to Instrument Panel Center Molding Replacement. |
|
|
1 |
Instrument Panel Center Upper Molding Procedures
|
Instrument Panel Center Trim Panel Replacement
Instrument Panel Compartment Door Dampener ReplacementDimensions - Body (5HB)
Point-to-point measurements are for reference only. All measurements are given
in millimeters. Use these measurements for diagnosing and estimating. Point-to-point
measurements are duplicated with tram bar pointers set at equal lengths. All die
marks, holes, slots, and fasteners are measured t ...
Intake Manifold Installation (1.8L LUW and LWE)
Clean the sealing surfaces.
Install 4 NEW gaskets.
Caution: Refer to Fastener Caution.
Install the intake manifold (2) and the 7 intake manifold bolts (1) and
tighten to 20 Y (15 lb ft).
Install the intake m ...
Engine Oil Cooler Inlet Pipe Replacement (LUW)
Removal Procedure
Drain the cooling system. Refer to Cooling System Draining and Filling.
Remove the exhaust manifold with catalytic converter. Refer to Exhaust
Manifold with Catalytic Converter Replacement.
Remove the engine oil cooler pipe bolts (1) an ...