Chevrolet Sonic Repair Manual: Seat Belt Service Precautions

Chevrolet Sonic Repair Manual / Body / Restraints / Primary / Seat Belt Service Precautions

Note:

If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision for additional information.

Do not bleach or dye the seat belt webbing. Use only the following items in order to clean the seat belt webbing:

A mild soap and water solution
A soft brush or cloth

Keep sharp edges and damaging objects away from the seat belts. Avoid bending or damaging any part of the seat belt buckle or the latch plate. Replace any seat belts which are cut or damaged in any way.
Use only the correct seat belt anchor bolts/screws and tighten the anchor bolts/screws to the correct torque value. Refer to Fastener Tightening Specifications. When installing seat belt anchor bolts, start the bolt by hand to ensure that the bolt is threaded straight.
Some seat belts and retractors require service as a set, with service replacement parts only. Do not attempt to repair to individual components that require service as a set.
Verify that the replacement part number is correct for the vehicle at that seating position. Do not substitute a seat belt from a different seating position.

Seat Belt Latch Stop Installation

Seat Belt Latch Stop Installation Callout Component Name Preliminary Procedure Locate the hole in the seat belt webbing where the o ...

Seat Belt System Description and Operation

Restraint System Note: If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision. The vehicle has front and rear seat belts that are th ...

Other materials:

License Plate Lamp
Lamp Assembly Bulb Assembly Bulb Socket Bulb Lamp Assembly To replace one of these bulbs: Push the left end of the lamp assembly toward the right. Turn the lamp assembly down to remove it. Turn the bulb socket (1) counterc ...

Brake Pedal Position Sensor Calibration
Calibration Criteria Note: Do not apply the brake pedal during the brake pedal position sensor calibration procedure. Any movement of the brake pedal during this procedure will cause the calibration procedure to fail. If this occurs, the brake pedal position sensor calibrati ...

Evaporative Emission Canister Vent Solenoid Valve Replacement
Evaporative Emission Canister Vent Solenoid Valve Replacement Callout Component Name Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the e ...

0.0071