Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
Pretensioner Handling and ScrappingTire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange,
remeasure the tire and wheel assembly on-vehicle runout in order to verify that
the amount of runout has been reduced and brought to within tolerances.
Mark the location of the high spot on the tire and wheel asse ...
Starter Replacement (LUV)
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and Connection.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
If equipped with a front suspension skid plate, remove the drivetrain
...
Special Tools
Illustration
Tool Number/Description
3-9607433
Transmission Support
DT-586
J-23129
KM-586
Universal Seal Remover
DT-3289-20
J-3289-20
Holding Fixture ...