Chevrolet Sonic Owner's Manual: Radio without Touchscreen
To set the time and date:
1. Press CLOCK.
2. Select Time and Date Settings.
3. Select Set Time or Set Date.
4. Turn the MENU/TUNE knob to adjust the highlighted value.
5. Press the MENU/TUNE knob to select the next value.
6. To save the time or date and return to the Time and Date Settings menu, press the / BACK button at any time or press the MENU/TUNE knob after adjusting the minutes or year.
To set the 12/24 hour format:
1. Press CLOCK.
2. Select Time and Date Settings.
3. Highlight Set Time Format.
4. Press the MENU/TUNE knob to select the 12 hour or 24 hour display format.
To set the month and day format:
1. Press CLOCK.
2. Select Time and Date Settings.
3. Highlight Set Date Format.
4. Press the MENU/TUNE knob to select MM/DD/YYYY (month/ day/year), or DD/MM/YYYY (day/month/year), or YYYY/MM/ DD (year/month/day).
Clock
The infotainment system controls are used to access the time and date settings
through the menu system. See Operation for information about how to
use the menu system. ...
Radio with Touchscreen
The infotainment system controls are used to access the time and date settings
through the menu system. See Operation for information about how to
use the menu system. ...
Other materials:
Rear Seat Head Restraint Replacement
Rear Seat Head Restraint Replacement
Callout
Component Name
1
Rear Seat Head Restraint
Preliminary Procedures
Depress the large button on the head restraint guide and raise the
head restraint to the full up p ...
Tire and Wheel Assembly Runout Measurement - Off Vehicle
Raise and support the vehicle.
Mark the location of the wheels to the wheel studs and mark the specific
vehicle position on each tire and wheel – LF, LR, RF, RR.
Remove the tire and wheel assemblies from the vehicle.
Closely inspect each tire for proper and even bead seating.
If an ...
Input Shaft Assemble
Special Tools
J-840733 Driver
For equivalent regional tools, refer to Special Tools.
Note: Ensure the input shaft rear bearing retaining ring (2) is
placed on the input shaft before installing the input shaft rear bearing
assembly (1).
Place the input sh ...
0.0049