Callout |
Component Name |
---|---|
1 |
Secondary Air Injection Outlet Pipe Note: Squeeze the retainer on opposite sides to release. |
2 |
Secondary Air Injection Check Valve Electrical Connector |
3 |
Secondary Air Injection Check Valve Bolts (Qty: 3). Caution: Refer to Fastener Caution.
25 Y (18 lb ft) |
4 |
Secondary Air Injection Check Valve |
5 |
Secondary Air Injection Check Valve Gasket |
SIR Identification Views
The SIR Identification Views shown below illustrate the approximate location
of all SIR components available for the vehicle. This will assist in determining
the appropriate SIR Disabling and Enabling for a given service procedure, refer
to SIR Disabling and Enabling.
Supplemental Inf ...
Brake Fluid
The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as
indicated on the reservoir cap. See Engine Compartment Overview for the location
of the reservoir.
There are only two reasons why the fluid level in the reservoir might go down:
The fluid level goes down b ...
Warm Up Three-Way Catalytic Converter Removal
Disconnect the heated oxygen sensor wiring harness (3) from retainer clip.
Remove the 2 catalytic converter to catalytic converter bracket nuts (4)
and (6).
Loosen the three way warm up catalytic converter V-clamp (1).
Remove the three way warm up ...