Chevrolet Sonic Repair Manual: Torque Converter Housing with Fluid Pump Assembly Installation (6T30)
|
Callout |
Component Name |
|---|---|
|
1 |
Fluid Pump Seal Assembly |
|
2 |
Torque Converter Housing Gasket |
|
3 |
Torque Converter (w/Fluid Pump) Housing Assembly Note: Rotate the differential slightly in each direction using DT-48277 rotating tool to align the Differential Pinion Gears with the Differential Ring Gear in the Torque Converter Housing. Special Tool
DT-48277 Differential Rotating Tool For equivalent regional tools, refer to Special Tools. |
|
4 |
Torque Converter and Differential Housing Bolts M8 x 30 (Qty: 14) Caution: Refer to Fastener Caution. Procedure
Tighten the bolts in sequence shown. Tighten
10 Y (89 lb in) then rotate the bolt an additional 50 degrees Special Tool
EN-45059 Angle Meter or equivalent For equivalent regional tools, refer to Special Tools. |
Torque Converter Housing Cleaning and Inspection
Torque Converter Housing Cleaning and Inspection
Callout
Component Name
Caution: After cleaning the transmission components, a ...
Torque Converter Housing with Fluid Pump Assembly Installation (6T40/45/50 Non
Hybrid)
Torque Converter Housing with Fluid Pump Assembly Installation
Callout
Component Name
1
Fluid Pump Seal Assembly
...
Other materials:
Brake Pedal Position Sensor Replacement
Removal Procedure
Remove the instrument panel lower trim pad cover. Refer to Instrument
Panel Lower Trim Pad Cover Replacement.
Disconnect the brake pedal position sensor electrical connector.
Remove the brake pedal position sensor bolt?€‰(1).
Remove t ...
Load Compartment (Hatchback)
The load compartment cover can be used to conceal objects under it or removed
and placed on the bottom of the load compartment to carry larger loads.
To remove the load compartment cover:
Lift up on the load compartment cover and pull out.
Store the load compartment cover on the bottom of ...
Strut and Shock Absorber Inspection (Shock Absorber)
Note: The shock absorber assembly DOES NOT have to be removed from
the vehicle to perform the following inspection procedure.
Note: A light film of oil on the top portion of the lower shock absorber
tube is normal. DO NOT replace the shock absorber for this condition.
Condition ...
0.006