Chevrolet Sonic Repair Manual: Transmission Component and System Description
The mechanical components of the 6T30/40/45/50 are as follows:
- A torque converter with an electronically controlled capacity clutch (ECCC)
- Gear-type fluid pump assembly
- 1??? and low and reverse clutch housing assembly
- 4?? and 3? reverse clutch housing assembly
- 2? clutch assembly
- Low and reverse clutch (one way clutch) assembly
- Control valve body assembly
- Drive sprocket, driven sprocket and link assembly
- Front differential carrier assembly
- Input Carrier Assembly
- Reaction Carrier Assembly
- Output Carrier Assembly
The electrical components of the 6T30/40/45 are as follows:
- Output speed sensor assembly
- Input speed sensor assembly
- Manual shift shaft with internal mode switch
- Control solenoid valve assembly, which contains the following components:
- Transmission control module (TCM)
- 5 variable bleed line pressure control (PC) solenoids
- Transmission fluid pressure (TFP) switch assembly
- Torque converter clutch (TCC) pressure control solenoid
- shift solenoid
- Transmission fluid temperature sensor
For more information, refer to Electronic Component Description.
Transmission Assemble (Gen 2)
Special Tools
3-9506289 Universal Adapter
R-0007758 Holding Fixture
S-9407197 Differential Rotating Tool
S-9407198 Differential Bearing Race Wrench
For equivalent regional tools, refer ...
Transmission Disassemble (Gen 1)
Special Tools
3-9506289 Universal Adapter
R-0007758 Holding Fixture
S-9407198 Differential Bearing Race Wrench
For equivalent regional tools, refer to Special Tools.
Attach R-0 ...
Other materials:
Communication Interface Module Bracket Replacement
Communication Interface Module Bracket Replacement
Callout
Component Name
Preliminary Procedure
Remove the instrument panel lower compartment. Refer to
Instrument Panel Lower Compartment Replacement
1
...
Valve Lifter Installation
Special Tool
EN-845 Suction Device
For equivalent regional tools, refer to Special Tools.
Note: Observe the correct locations.
Note: Coat the sliding surfaces with NEW engine oil.
Install the 16 valve lifter (1), using the EN-845 suction device . ...
Oil Flow Check Valve Replacement
Oil Flow Check Valve Replacement
Callout
Component Name
Preliminary Procedure
Remove the generator. Refer to Generator Replacement.
1
Oil Flow Check Valve Bore Plug
Caution: Refer to Fastene ...
0.0082