Chevrolet Sonic Repair Manual: Transmission System Description and Operation
The F17 is a 5 speed manual transmission assembly.
Note:
Use only transmission fluid listed within the Adhesives, Fluids, Lubricants, and Sealers for this manual transmission assembly. Other lubricants or additives may affect the shift performance.
The F17 (Gen 1) 5 Speed manual transmission has the following features:
- First and second gear double coned synchronizer
- Third, fourth, and fifth gear single coned synchronizer
- Two shaft design consisting of an input shaft, and main shaft
- Reverse inhibit feature
- One piece clutch actuator ?no bleed screw
- Transmission venting system is part of the fill cap
- Vehicle speed sensor (VSS)
The F17 (Gen 2) 5 Speed manual transmission has the following features:
- First, second, third, and fourth gear double coned synchronizer
- Fifth gear single coned synchronizer
- Two shaft design consisting of an input shaft, and main shaft
- Synchronized Reverse Gear
- One piece clutch actuator ?no bleed screw
- Transmission venting system is part of the fill cap
- Vehicle speed sensor (VSS)
The manual transmission shift cables must be adjusted for proper shifter performance.
Transmission Replacement (With 1.6L or 1.8L Engine)
Removal Procedure
Remove the battery tray. Refer to
Battery Tray Replacement.
Without draining the coolant or removing the hoses,
remove and position aside the radiator surge t ...
Vehicle, Engine and Transmission ID and VIN Location, Derivative and Usage
The vehicle identification number (VIN) plate is the legal identifier of the
vehicle. The VIN plate is located on the upper left corner of the instrument panel
(I/P) and can be seen through th ...
Other materials:
Questions and Answers About Safety Belts
Q: Will I be trapped in the vehicle after a crash if I am wearing a safety belt?
A: You could be— whether you are wearing a safety belt or not. Your chance of being
conscious during and after a crash, so you can unbuckle and get out, is much greater
if you are belted.
Q: If my vehicle has ai ...
Brake Shoe Replacement (J93, J94)
Removal Procedure
Warning: Refer to Brake Dust Warning.
Note: Always replace brake shoes in axle sets.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and In ...
Cylinder Head Removal
Loosen the 12 cylinder head bolts in the sequence as shown. Use the following
procedure:
Loosen the cylinder head bolts 90 degrees.
Loosen the cylinder head bolts 180 degrees.
Note: Do not damage the guide sleeves (4) and (5).
R ...
0.0091